Dell Thunderbolt Dock WD22TB4 User Guide

PDF

Setting up your docking station

Steps

  1. Update your system's BIOS, graphics, thunderbolt and network drivers from www.dell.com/support/drivers.
    NOTE:Thunderbolt driver updates are only for systems that are natively configured with Thunderbolt hardware and is not applicable for Non-thunderbolt systems.
    CAUTION:Ensure that the system is connected to a power source while installing the BIOS and drivers.
    Updating the BIOS, graphics, thunderbolt, and network drivers
  2. Connect the AC adapter to a power outlet. Then, connect the AC adapter to the 7.4 mm DC-in power input on the Dell Thunderbolt Dock - WD22TB4.
    Connecting the AC Adapter
  3. Connect the USB Type-C connector to the system.

    Update the Dell Thunderbolt Dock firmware from www.dell.com/support/drivers.

  4. Connect multiple displays to the docking station, as needed.
    Connecting multiple displays
    The above table shows the different video port combinations available to connect multiple displays to the Dell WD22TB4 dock. For more details on supported display resolutions, please see Display Resolution.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\