Latitude 7290 Owner's Manual

Installing display assembly

1. Place the base of the computer on a clean flat surface.
2. Install the display assembly to align it with the display hinge holders on the system.
3. Holding the display assembly, replace the six (M2.5 x 3.5) screws to secure the display hinges on the system display assembly with the system unit.
4. Route the eDP cable from the routing channel.
5. Affix the tapes to secure the eDP cable (display cable) to the system board.
6. Connect the eDP cable to the connector on the system board.
   NOTE WLAN and WWAN antennas must be routed correctly into the routing pads on the system board and protective sleeves must be used to isolate the antenna connectors.
7. Install the eDP metal bracket on the eDP cable and tighten the M2.0 x 3.0 screws.
8. Route the WLAN and WWAN cables through the routing channels.
9. Install the:
   1. WLAN card
   2. WWAN card
   3. battery
   4. base cover
10. Follow the procedure in After working inside your computer.