Latitude 7290 Owner's Manual

Removing speaker module

1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Disconnect the battery cable from the connector on the system board.
4. To release the speaker module:
   1. Disconnect the speaker cable from the connector on the system board [1].
      NOTE Use a plastic scribe to release the cable from the connector. Do not pull the cable as it may result in breakage
   2. Un-route the speaker cable from the two routing clips on the side of touchpad buttons [2].
   3. Remove the tape that secures the speaker cables to the touchpad board [3].
   
5. To remove the speaker module:
   1. Remove the four (M2.0 x 3.0) screws that secure the speaker module to the system [1].
      NOTE Refer the speaker screw list.
      
   2. Lift the speaker module from the computer [2].