- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Inspiron 14 5415
- Base cover
- Battery cable
- Battery
- Coin-cell battery
- Solid-state drive
- Memory module
- Wireless card
- Power-adapter port
- Display assembly
- I/O board
- Speakers
- Touchpad
- Fan
- Heat sink
- Power button with optional fingerprint reader
- System board
- Palm-rest and keyboard assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
Inspiron 14 5415 Service Manual
Installing the heat sink
Prerequisites
About this task
NOTE If either the system board or the heat sink is replaced, use the thermal grease provided in the kit to ensure that thermal conductivity is achieved.
The following image(s) indicate the location of the heat sink and provides a visual representation of the installation procedure.
Steps
- Place the heat-sink on the system board.
- Align the screw holes on the heat sink to the screw holes on the system board.
- In sequential order (1>2>3>4>5>6>7) tighten the seven captive screws that secure the heat sink to the system board.NOTE The number of screws varies depending on the configuration ordered.
Next steps
- Install the base cover.
- Follow the procedure in After working inside your computer.
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
この記事は役に立ちましたか?
コメントでは、以下の特殊文字は利用できません: <>()\