- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Inspiron 14 5415
- Base cover
- Battery cable
- Battery
- Coin-cell battery
- Solid-state drive
- Memory module
- Wireless card
- Power-adapter port
- Display assembly
- I/O board
- Speakers
- Touchpad
- Fan
- Heat sink
- Power button with optional fingerprint reader
- System board
- Palm-rest and keyboard assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
Inspiron 14 5415 Service Manual
Installing the M.2 2230 solid-state drive
Prerequisites
About this task
NOTE This procedure applies if you are installing a M.2 2230 solid-state drive.
NOTE The M.2 card installed on your computer will depend on the configuration ordered. Supported card configurations on the M.2 card slot:
- M.2 2230 solid-state drive + M.2 2230 solid-state drive mounting bracket
- M.2 2280 solid-state drive
The following image(s) indicate the location of the M.2 2230 solid-state drive and provides a visual representation of the installation procedure.
Steps
- Align the notch on the M.2 2230 solid-state drive with the tab on the M.2 card slot on the system board.
- Slide the M.2 2230 solid-state drive into the M.2 card slot on the system board.
- Replace the screw (M2x3) that secures the M.2 2230 solid-state drive to the system board.
Next steps
- Install the base cover.
- Follow the procedure in After working inside your computer.
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
この記事は役に立ちましたか?
コメントでは、以下の特殊文字は利用できません: <>()\