- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Inspiron 14 5415
- Base cover
- Battery cable
- Battery
- Coin-cell battery
- Solid-state drive
- Memory module
- Wireless card
- Power-adapter port
- Display assembly
- I/O board
- Speakers
- Touchpad
- Fan
- Heat sink
- Power button with optional fingerprint reader
- System board
- Palm-rest and keyboard assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
Inspiron 14 5415 Service Manual
Removing the heat sink
Prerequisites
- Follow the procedure in Before working inside your computer.
- Remove the base cover.
About this task
CAUTION The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to cool before you touch it.
NOTE For maximum cooling of the processor, do not touch the heat transfer areas on the heat sink. The oils in your skin can reduce the heat transfer capability of the thermal grease.
The following image(s) indicate the location of the heat sink and provides a visual representation of the removal procedure.
Steps
- In reverse sequential order (7>6>5>4>3>2>1) loosen the seven captive screws that secure the heat sink to the system board.NOTE The number of screws varies depending on the configuration ordered.
- Lift the heat sink from the system board.
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
この記事は役に立ちましたか?
コメントでは、以下の特殊文字は利用できません: <>()\