- Notes, cautions, and warnings
- Notes, cautions, and warnings
- Working on your computer
- System Overview
- Disassembly and reassembly
- Recommended tools
- Press latch doors
- Stylus and tether
- Battery
- Hard drive
- Optical drive
- Base cover
- Optical drive connector
- Hard drive tray
- Smart card module
- Keyboard lattice and Keyboard
- Memory modules
- Chasis Frame
- Graphics Processing Unit (GPU)
- Subscriber Identity Module(SIM) board
- WLAN card
- WWAN card
- GPS board
- Heat sink
- System fan
- RF cable holder
- Display assembly
- Display panel
- Input-Output board
- Coin cell battery
- Driving board
- Battery connector
- System board
- Power connector port
- Camera
- Diagnostics
- Using your computer
- Technology and components
- System setup
- Technical specifications
- System information specifications
- Processor specifications
- Memory specifications
- Battery specifications
- Audio specifications
- Video specifications
- Communication specifications
- Port and connector specifications
- Display specifications
- Touchpad specifications
- Keyboard specifications
- Adapter specifications
- Physical dimension specifications
- Environmental specifications
- Troubleshooting
- Contacting Dell
Dell Latitude 14 Rugged — 5414 Series Owner's Manual
Installing the base cover
- Tighten the screws to secure I/O, back door, and HDMI to the computer chassis.
- Press firmly on the latch doors until a click is heard and the latch is engaged.
- Place the base cover on the base of the computer.
- Tighten the screws to secure the base cover to the computer chassis.
- Install the:
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\