Error messages
This section describes the error messages that are displayed on the screen during POST or captured in the
system event log (SEL)/LifeCycle (LC) log.
Table 1. Error message HWC8010This table describes the error message HWC8010.
Error code
|
HWC8010
|
Message
|
The System Configuration Check operation that is resulted in the following issue involving the indicated component type
|
Arguments
|
Riser, floating card (fPERC, adapter PERC, BOSS), backplane, processor, cable, or other components
|
Detailed Description
|
The issue that is identified in the message is observed in the System Configuration Check operation.
|
Recommended Response Action
|
Do the following and retry the operation:
- Disconnect the input power.
- Check for proper cable connection and component placement. If the issue persists, contact the service provider.
|
Category
|
System Health (HWC = Hardware Config)
|
Severity
|
Critical
|
Trap/EventID
|
2329
|
Table 2. Error message HWC8011This table describes the error message HWC8011.
Error code
|
HWC8011
|
Message
|
The System Configuration Check operation that is resulted in multiple issues involving the indicated component type
|
Arguments
|
Riser, floating card (fPERC, adapter PERC, BOSS), backplane, processor, cable, or other components
|
Detailed Description
|
Multiple issues are observed in the System Configuration Check operation.
|
Recommended Response Action
|
Do the following and retry the operation:
- Disconnect the input power.
- Check for proper cable connection and component placement. If the issue persists, contact the service provider.
|
Category
|
System Health (HWC = Hardware Config)
|
Severity
|
Critical
|