Dell PowerEdge T360 Installation and Service Manual

Removing the system board

Prerequisites

CAUTION:If you are using the Trusted Platform Module (TPM) with an encryption key, you may be prompted to create a recovery key during program or System Setup. Be sure to create and safely store this recovery key. If you replace this system board, you must supply the recovery key when you restart your system or program before you can access the encrypted data on your drives.

Follow the safety guidelines listed in the Safety instructions.
Follow the procedure listed in the Before working inside your system.
Remove the following components:
1. Air shroud
2. Cooling fans
3. Memory modules
4. Expansion cards
5. Processor and heat sink module
6. Trusted Platform Module
7. Disconnect all the cables from the system board and make note of all the cable connections.
  CAUTION:Take care not to damage the system identification button while removing the system board from the system.
  CAUTION: Do not lift the system board by holding a memory module, processor, or other components.

Steps

Using the system board holder and plunger, slide the system board towards the front of the system.
At a tilted angle, lift the system board out of the chassis.
Figure 1. Removing the system board

Next steps

Replace the system board.

歡迎

歡迎來到 Dell

Dell PowerEdge T360 Installation and Service Manual

Removing the system board

Prerequisites

Steps

Next steps

對此內容評分