Dell PowerEdge T360 Installation and Service Manual

Removing the BOSS-N1 card carrier

Open the release latch and slide the BOSS-N1 card carrier out of the BOSS-N1 module.
Figure 1. Removing the BOSS-N1 card carrier
Using the Phillips 1 screwdriver removes the M3 x 0.5 x 4.5 mm screw that secures the M.2 NVMe SSD to the BOSS-N1 card carrier.
Slide the M.2 NVMe SSD out from the BOSS-N1 card carrier.
Figure 2. Removing the M.2 NVMe SSD
If not installing the BOSS-N1 card carrier, align and push the BOSS-N1 card carrier blank into the BOSS-N1 module to fill the empty BOSS-N1 card carrier slot.
Figure 3. Installing the BOSS-N1 card carrier blank