跳至主要內容
登出

歡迎來到 Dell

我的帳戶
  • 簡單快速地下訂單
  • 檢視訂單及追蹤商品運送狀態
  • 建立並存取您的產品清單
  • 使用「公司管理」來管理您的 Dell EMC 網站、產品和產品層級連絡人。
登入 建立帳戶 Premier 登入 合作夥伴計畫登入
與我們連絡

您的 Dell.com 購物車

Dell PowerEdge T360 Installation and Service Manual

PDF

Installing an expansion card

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. If required, remove the air shroud.

Steps

  1. Loosen the captive screw and tilt the metal bracket that holds the metal filler.
    NOTE:Store this bracket for future use. Filler brackets must be installed in empty expansion-card slots to maintain FCC certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system.
  2. Lift the metal filler out of the system.
    Figure 1. Removing the metal filler
    This image shows how to remove the metal filler bracket.
  3. Holding the card by the edges, align the card with the expansion card slot on the system board.
  4. Insert the card firmly into the expansion card slot until the card is firmly seated.
    Figure 2. Installing an expansion card
    This image shows how to install an expansion card.
  5. Tilt the metal bracket and tighten the captive screw.

Next steps

  1. If required, reconnect the cables to the expansion card.
  2. Install the air shroud.
  3. Follow the procedure listed in After working inside your system.

對此內容評分

準確
實用
易懂
這篇文章對您有用嗎？
0/3000 characters
  請給予評分 (1 到 5 顆星)。
  請給予評分 (1 到 5 顆星)。
  請給予評分 (1 到 5 顆星)。
  本文章是否有幫助？請選擇。
  評語中不得包含下列特殊字元：<>()\