Dell PowerEdge T360 Installation and Service Manual

Installing the control panel assembly

To install control panel assembly:
1. Align and slide the control panel assembly into the control panel cage.
2. Using a Phillips 2 screwdriver, tighten the screws that secure the control panel assembly to the cage.
  Figure 1. Installing the control panel assembly
To install control panel cage:
1. Connect the cable to the control panel assembly.
2. Slide the control panel cage into the system until clicks into its place.
Figure 2. Installing the control panel cage
Insert front faceplate tabs into the slots in the system and press until the front faceplate locks into place.
Figure 3. Installing the front faceplate
Tilt at an angle and align the system side cover with the slots in the system, then slide the cover towards the front of the system until locks into place.
Using a Phillips 2 screwdriver, tighten the screws that secure the system side cover to the chassis.
Figure 4. Installing the system side cover

Connect the control panel cable and the control panel USB cable to the system board.
NOTE:Secure the control panel cables with the cable tie to prevent it form being pinched or crimped.
Follow the procedure listed in After working inside your system.