跳至主要內容
登出

歡迎來到 Dell

我的帳戶
  • 簡單快速地下訂單
  • 檢視訂單及追蹤商品運送狀態
  • 建立並存取您的產品清單
  • 使用「公司管理」來管理您的 Dell EMC 網站、產品和產品層級連絡人。
登入 建立帳戶 Premier 登入 合作夥伴計畫登入
與我們連絡

您的 Dell.com 購物車

Dell PowerEdge T360 Installation and Service Manual

PDF

Installing the system board

Prerequisites

NOTE:Before replacing the system board, replace the old iDRAC MAC address label on the Express Service Tag with the iDRAC MAC address label of the replacement system board.
  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. If you are replacing the system board, remove all the components that are listed in the removing the system board section.

Steps

  1. Unpack the new system board assembly.
    CAUTION: Do not lift the system board by holding a memory module, processor, or other components.
    CAUTION:Take care not to damage the system identification button while placing the system board into the chassis.
  2. Holding the system board holder and plunger, lower the system board at a tilted angle into the system.
  3. Slide the system board towards the rear of the chassis until the connectors are firmly seated in the slots.
    Figure 1. Installing the system board
    This image show the installation of the system board.

Next steps

  1. Replace the following components:
    1. Trusted Platform Module (TPM)
      NOTE:The TPM Module must be replaced only while installing new system board.
    2. Processor and heat sink module
    3. Memory modules
    4. Expansion cards
    5. Cooling fans
    6. Air shroud
  2. Reconnect all cables to the system board.
    NOTE:Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing bracket.
  3. Ensure that you perform the following steps:
    1. Use the Easy Restore feature to restore the Service Tag. See the Restoring the system by using the Easy Restore feature section.
    2. If the service tag is not backed up in the backup flash device, enter the system service tag manually. See the Manually update the Service Tag by using System Setup section.
    3. Update the BIOS and iDRAC versions.
    4. Re-enable the Trusted Platform Module (TPM). See the Upgrading the Trusted Platform Module section.
  4. Follow the procedure listed in After working inside your system.

對此內容評分

準確
實用
易懂
這篇文章對您有用嗎？
0/3000 characters
  請給予評分 (1 到 5 顆星)。
  請給予評分 (1 到 5 顆星)。
  請給予評分 (1 到 5 顆星)。
  本文章是否有幫助？請選擇。
  評語中不得包含下列特殊字元：<>()\