Removal
System Cover
Identify the system cover highlighted in blue.
Using a flat head or a Phillips screwdriver, rotate the lock counter clockwise.
Lift the latch till the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Cooling Shroud
Identify the air shroud highlighted in blue
Holding the touch points, lift the cooling shroud away from the system.
Cooling fan assembly
Identify the cooling fan assembly highlighted in blue.
Lift both release levers simultaneously to unlock the assembly.
Hold both release levers, and lift the assembly away from the system
Hard Drive Backplane
Identify the hard drive backplane highlighted in blue
Using the blue touchpoints, slide the backplane cover back and lift to remove.
Press the release button to open the drive carrier release handle on all hard drives installed.
Holding the handle, pull the drive out partially to disengage from the drive plane.
Press the 2 blue release tabs, partially lift the backplane to disengage to access the cables.
Disconnect all data, signal, and power cable(s) from the backplane.
Lift to remove the backplane from the system.
Install
Hard Drive Backplane
Identify the hard drive backplane location highlighted in blue
Connect the all data, signal, and power cable(s) to the backplane.
Align the backplane to the hooks on the chassis and lower until the release tabs snap into place.
Slide the drives into place and close to latch to secure.
Lower the backplace cover into the slot and slide until it snaps into place.
Cooling fan assembly
Identify the cooling fan location highlighted in blue.
Align the guide rails on the cooling fan assembly with the standoffs on the system
Lower the cooling fan assembly into the system
Press both release levers to lock the cooling fan assembly into the system
Cooling Shroud
Identify the cooling shroud location highlighted in blue
Align the tabs on the air shroud with the slots on the system.
Lower the air shroud into the system until it is firmly seated.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system.
Push the system cover latch down.
Using a flat head or Phillips screwdriver, rotate the lock clockwise.