Removal
System Cover
Identify the system cover highlighted in blue.
Using a flat head or a Phillips screwdriver, rotate the lock counter clockwise.
Lift the latch till the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Cooling Shroud
Identify the air shroud highlighted in blue
Holding the touch points, lift the cooling shroud away from the system.
Cooling fan assembly
Identify the cooling fan assembly highlighted in blue.
Lift both release levers simultaneously to unlock the assembly.
Hold both release levers, and lift the assembly away from the system
Control panel -Left
Identify the control panel highlighted in blue
Pull the cable latch and disconnect the control panel cable from the system board connector
Remove the screws which secure the left control panel assembly to the system
Remove the control panel assembly from the system.
Install
Control panel -Left
Identify the control panel location highlighted in blue
Route the control panel cable through the side wall of the system
Align the left control panel assembly with the slot and slide into place
Connect the control panel cable to the system board connector and secure it using cable latch
Install the screws that secure the control panel assembly to the system
Cooling fan assembly
Identify the cooling fan location highlighted in blue.
Align the guide rails on the cooling fan assembly with the standoffs on the system
Lower the cooling fan assembly into the system
Press both release levers to lock the cooling fan assembly into the system
Cooling Shroud
Identify the cooling shroud location highlighted in blue
Align the tabs on the air shroud with the slots on the system.
Lower the air shroud into the system until it is firmly seated.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system.
Push the system cover latch down.
Using a flat head or Phillips screwdriver, rotate the lock clockwise.