Removal
System Cover
Identify the system cover highlighted in blue.
Using a flat head or a Phillips screwdriver, rotate the lock counter clockwise.
Lift the latch till the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Cooling Shroud
Identify the air shroud highlighted in blue
Holding the touch points, lift the cooling shroud away from the system.
Expansion Card 03
Identify the expansion card highlighted in blue.
Pull the expansion card latch out of the slot.
Hold the expansion card by its edges, and pull the card from the system
Riser 3
Identify the expansion card riser 3 highlighted in blue
Loosen the screws that secure the riser to the system
Press the release tab and lift the riser from the system board
Install
Riser 3
Identify the expansion card riser 3 location highlighted in blue
Align the tab on the riser with the slot on the system, and guide rails on the riser with the standoffs on the side of the system
Lower the riser into the system until the riser connector engages with the connector on the system board
Tighten the screws to secure the riser to the system
Expansion Card 03
Identify the expansion card location highlighted in blue.
Insert the card edge connector firmly into the expansion card connector until the card is fully seated.
Push the expansion card latch
Cooling Shroud
Identify the cooling shroud location highlighted in blue
Align the tabs on the air shroud with the slots on the system.
Lower the air shroud into the system until it is firmly seated.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system.
Push the system cover latch down.
Using a flat head or Phillips screwdriver, rotate the lock clockwise.