Removal
System Cover
Identify the system cover highlighted in blue.
Using a flat head or a Phillips screwdriver, rotate the lock counter clockwise.
Lift the latch till the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Cooling Shroud
Identify the air shroud highlighted in blue
Holding the touch points, lift the cooling shroud away from the system.
Integrated storage controller card
Identify the integrated storage controller card highlighted in blue
Loosen the screws that secure the cable to the card connector on the system board
Lift the cable away from the integrated storage controller.
Lift the connector side of the card to a 45 degree angle to disengage the card and lift out of the system
Pull up on the interposer board by its edges until the board disengages from the connector
Install
Integrated storage controller card
Identify the Integrated Storage Controller location on the system board.
Align the interposer board and press the touch point until the card connector is firmly seated.
Angle the card to engage it with the integrated storage controller card holder on the system board.
Lower the card into place until its fully seated.
Tighten the screws to secure the integrated storage controller card cable to the system board.
Cooling Shroud
Identify the cooling shroud location highlighted in blue
Align the tabs on the air shroud with the slots on the system.
Lower the air shroud into the system until it is firmly seated.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system.
Push the system cover latch down.
Using a flat head or Phillips screwdriver, rotate the lock clockwise.