Μετάβαση στο κύριο περιεχόμενο
Έξοδος

Καλώς ορίσατε στην Dell

Ο λογαριασμός μου
  • Υποβάλετε παραγγελίες γρήγορα και εύκολα
  • Δείτε τις παραγγελίες και παρακολουθήστε την κατάσταση αποστολής
  • Δημιουργήστε μια λίστα με τα προϊόντα σας για να έχετε πρόσβαση σε αυτή
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Είσοδος Δημιουργήστε έναν λογαριασμό Είσοδος στο Premier Είσοδος στο Πρόγραμμα συνεργατών
Επικοινωνία

Dell PowerVault MD3060e Storage Enclosure Owner's Manual

PDF

Physical Disk Installation Guidelines

To maintain proper airflow, install physicals disks from left to right and front to back in each drawer. The following table lists the slot numbers of the physical disks and the order in which the disks need to be installed.
Physical Disk Installation OrderSlot Number
10
23
36
49
51
64
77
810
92
105
118
1211
Figure 1. Slot Numbering on the Disk Drawer This figure shows the slot numbering on the physical-disk drawer.
  • NOTE: If you need to install less than 12 physical disks, you must follow the recommended physical disk installation order. For example if you have to install only 7 disks, the order of installation should be 0, 3, 6, 9, 1, 4, and 7.
  • A minimum of four disks must be installed in the front slots 0, 3, 6, and 9 of each drawer.
  • The MD3060e storage enclosure supports mixing of physical disk types.
    • NOTE: 3.5" 10k and 15k RPM SAS drives are not supported. For the latest drive support, refer to Dell Enclosure Storage Support Matrix at: Dell.com/powervaultmanuals.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\