Μετάβαση στο κύριο περιεχόμενο
Έξοδος

Καλώς ορίσατε στην Dell

Ο λογαριασμός μου
  • Υποβάλετε παραγγελίες γρήγορα και εύκολα
  • Δείτε τις παραγγελίες και παρακολουθήστε την κατάσταση αποστολής
  • Δημιουργήστε μια λίστα με τα προϊόντα σας για να έχετε πρόσβαση σε αυτή
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Είσοδος Δημιουργήστε έναν λογαριασμό Είσοδος στο Premier Είσοδος στο Πρόγραμμα συνεργατών
Επικοινωνία

Dell PowerVault MD3060e Storage Enclosure Owner's Manual

PDF

Removing An Enclosure Management Module

  • CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  • CAUTION: To avoid damage to the sensitive EMI contacts on the module, do not stack the modules.
  1. Identify and locate the enclosure management module that you want to replace.
  2. Disconnect the cables connected to the RAID controller module, enclosure management module, or server.
  3. Push down on the release tab and pull the release lever away from the chassis.
  4. Hold the release lever and pull the module away from the chassis.
    Figure 1. Removing and Installing an Enclosure Management Module This figure shows removing and installing an enclosure management module.
    1. enclosure management module
    2. release lever
    3. release tab

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\