Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

ip access-group

Apply an egress IP ACL to an interface.

Syntax

ip access-group access-list-name {in | out} [implicit-permit] [vlan vlan-id]

Parameters

access-list-name	Enter the name of a configured access list, up to 140 characters.
in	Enter the keyword `in` to apply the ACL to incoming traffic.
out	Enter the keyword `out` to apply the ACL to the outgoing traffic.
implicit-permit	(OPTIONAL) Enter the keyword `implicit-permit` to change the default action of the ACL from implicit-deny to implicit-permit (that is, if the traffic does not match the filters in the ACL, the traffic is permitted instead of dropped).
vlan vlan-id	(OPTIONAL) Enter the keyword `vlan` then the ID numbers of the VLANs.

Defaults

Not enabled..

Command Modes

INTERFACE

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module platform.

Usage Information

You can assign one ACL (standard or extended ACL) to an interface..

NOTE: This command is not supported on the FN IOMSwitch Loopback interfaces.

NOTE: If outbound(egress) IP ACL is applied on switch port, filter will be applied only for routed traffic egressing out of that port.

Related Commands

ip access-list standard — configures a standard ACL.

ip access-list extended — configures an extended ACL.