Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

qos dscp-color-policy

Associates the DSCP color map profile with an interface so that all IP packets received on it is given a color based on that color map.

Syntax

dscp-color-policy color-map-profile-name

To remove a color policy map profile, use the no dscp-color-policy color-map-profile-namecommand.

Parameters

color-map-profile-name

Enter the color map profile name. The name can have a maximum of 32 characters.

Defaults

None

Command Modes

CONFIG-INTERFACE

Supported Modes

Full–Switch

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.7(0.0)	Introduced on the S6000-ON.
Version 9.5.0.0	Introduced on the Z9000, S6000, S4820T, S4810, and MXL.

Usage Information

If the specified color-map does not exist, the Diffserv Manager (DSM) creates a color map and sets all the DSCP values to green (low drop precedence).

Example

The following example assigns the color map, bat-enclave-map, to interface.

Related Commands

dscp — sets the number of specific DSCP values for color map profile to yellow or red.

qos dscp-color-map — configures the DSCP color map.