Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

ip msdp default-peer

Define a default peer from which to accept all source-active (SA) messages.

Syntax

ip msdp default-peer peer address [list name]

To remove the default peer, use the no ip msdp default-peer { peer address} list name command.

Parameters

peer address	Enter the peer address in a dotted decimal format (A.B.C.D.)
list name	Enter the keywords `list name` and specify a standard access list that contains the RP address that should be treated as the default peer. If no access list is specified, then all SAs from the peer are accepted.

Defaults

Not configured.

Command Modes

CONFIGURATION

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

If a list is not specified, all SA messages received from the default peer are accepted. You can enter multiple default peer commands.