Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

storm-control broadcast (Configuration)

Configure the percentage of broadcast traffic allowed in the network.

Syntax storm-control broadcast [ packets_per_second in]

To disable broadcast rate-limiting, use the no storm-control broadcast [ packets_per_second in] command.

Parameters
packets_per_second Enter the packets per second of broadcast traffic allowed into the network. The range is from 0 to 33554368.
Defaults none
Command Modes CONFIGURATION (conf)
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information Broadcast storm control is valid on Layer 2/Layer 3 interfaces only. Layer 2 broadcast traffic is treated as unknown-unicast traffic.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\