Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

PDF

Setting VRRP Group (Virtual Router) Priority

Setting a virtual router priority to 255 ensures that router is the “owner” virtual router for the VRRP group. VRRP elects the MASTER router by choosing the router with the highest priority.

The default priority for a virtual router is 100. The higher the number, the higher the priority. If the MASTER router fails, VRRP begins the election process to choose a new MASTER router based on the next-highest priority.

If two routers in a VRRP group come up at the same time and have the same priority value, the interface’s physical IP addresses are used as tie-breakers to decide which is MASTER. The router with the higher IP address becomes MASTER.

To configure the VRRP group’s priority, use the following command.

Configure the priority for the VRRP group. INTERFACE -VRID mode priority priority The range is from 1 to 255. The default is 100.

Example of the priority Command

Dell(conf-if-te-1/2)#vrrp-group 111
                                 Dell(conf-if-te-1/2-vrid-111)#priority 125
                              

Example of Verifying the VRRP Group Priority

Dell#show vrrp
                                 ------------------
                                 Tengigabitethernet 1/1, VRID: 111, Net: 10.10.10.1
                                 State: Master, 
                                 Priority: 255, Master: 10.10.10.1 (local)
                                 Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec
                                 Adv rcvd: 0, Bad pkts rcvd: 0, Adv sent: 2343, Gratuitous ARP sent: 5
                                 Virtual MAC address:
                                 00:00:5e:00:01:6f
                                 Virtual IP address:
                                 10.10.10.1 10.10.10.2 10.10.10.3 10.10.10.10
                                 Authentication: (none)
                                 ------------------
                                 Tengigabitethernet 1/2, VRID: 111, Net: 10.10.2.1
                                 State: Master, 
                                 Priority: 125, Master: 10.10.2.1 (local)
                                 Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec
                                 Adv rcvd: 0, Bad pkts rcvd: 0, Adv sent: 601, Gratuitous ARP sent: 2
                                 Virtual MAC address:
                                 00:00:5e:00:01:6f
                                 Virtual IP address:
                                 10.10.2.2 10.10.2.3
                                 Authentication: (none)
                                 Dell(conf)#
                              

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\