Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Baskets

Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

PDF

Undoing Commands

When you enter a command, the command line is added to the running configuration file (running-config).

To disable a command and remove it from the running-config, enter the no command, then the original command. For example, to delete an IP address configured on an interface, use the no ip address ip-address command.

Example of Viewing Disabled Commands 

Dell(conf)# interface managementethernet 0/0
                                 Dell(conf-if-ma-0/0)# ip address 192.168.5.6/16
                                 Dell(conf-if-ma-0/0)#
                                 Dell(conf-if-ma-0/0)#
                                 Dell(conf-if-ma-0/0)#show config
                                 !
                                 interface ManagementEthernet 0/0
                                 ip address 192.168.5.6/16
                                 no shutdown
                                 Dell(conf-if-ma-0/0)#
                                 Dell(conf-if-ma-0/0)# no ip address
                                 Dell(conf-if-ma-0/0)#
                                 Dell(conf-if-ma-0/0)# show config
                                 !
                                 interface ManagementEthernet 0/0
                                 no ip address
                                 no shutdown
                                 Dell(conf-if-ma-0/0)#

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\