Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

ip ospf cost

Change the cost associated with the OSPF traffic on an interface.

Syntax ip ospf cost cost

To return to default value, use the no ip ospf cost command.

Parameters
cost Enter a number as the cost. The range is from 1 to 65535.
Defaults The default cost is based on the reference bandwidth.
Command Modes INTERFACE
Supported Modes Full—Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information

If this command is not configured, cost is based on the auto-cost command.

When you configure OSPF over multiple vendors, to ensure that all routers use the same cost, use the ip ospf cost command. Otherwise, OSPF routes improperly.

Related Commands auto-cost — controls how the OSPF interface cost is calculated.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\