Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

qos dscp-color-map

Configure the DSCP color map.

Syntax

qos dscp-color-map map-name

To remove a color map, use the no qos dscp-color-map map-name command.

Parameters

map-name

Enter the name of the DSCP color map. The map name can have a maximum of 32 characters.

Defaults

None

Command Modes

CONFIGURATION

Supported Modes

Full–Switch

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.7(0.0)	Introduced on the S6000-ON.
9.5.0.0	Introduced on the Z9000, S6000, S4820T, S4810, and MXL.

Usage Information

A color map outlines the codepoint mappings to the appropriate color mapping (green, yellow, red) for the traffic. The system uses this information use to handle the traffic on the interface based on the traffic priority and places it into the appropriate shaping queue. You cannot delete a DSCP color map when it is configured on an interface. If you do, all the DSCP values are set to green (low drop precedence). To delete the DSCP color map that is being used by one or more interfaces, remove the DSCP map from each interface.

Example

Dell(conf)#qos dscp-color-map mymap

Related Commands

qos dscp-color-map — associates the DSCP color map profile with an interface so that all IP packets received on it is given a color based on that color map

dscp — sets the number of specific DSCP values for color map profile to yellow or red.