Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

tunnel source

Set a source address for the tunnel.

Syntax tunnel source { ip-address | ipv6–address | interface-type-number}

To delete the current tunnel source address, use the no tunnel source command.

Parameters
ip-address Enter the source IPv4 address in A.B.C.D format.
ipv6–address Enter the source IPv6 address in X:X:X:X::X format.
interface-type-number
  • For a Port Channel interface, enter the keywords port-channel then a number from 1 to 128.
  • For a 10–Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.
  • For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults none
Command Modes INTERFACE TUNNEL (conf-if-tu)
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information

If you configure a tunnel interface or destination address, the tunnel source must be compatible.

If you configure a tunnel source address as an interface, the tunnel does not function until the compatible address is present on the particular interface.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\