Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

vlan-stack protocol-type

Define the stackable VLAN tag protocol identifier (TPID) for the outer VLAN tag (also called the VMAN tag). If you do not configure this command, the system assigns the value 0x9100.

Syntax vlan-stack protocol-type number
Parameters
number Enter the hexadecimal number as the stackable VLAN tag.

You may specify both bytes of the 2-byte S-Tag TPID. The range is from 0 to FFFF. The default is 9100.

Defaults 0x9100
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information

For specific interoperability limitations regarding the S-Tag TPID, refer to the Dell Networking OS Configuration Guide .

Related Commands

portmode hybrid — sets a port (physical ports only) to accept both tagged and untagged frames. A port configured this way is identified as a hybrid port in report displays.

vlan-stack trunk — specifies a Layer 2 port or port channel as a trunk port to the Stackable VLAN network.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\