- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Chromebook 3110 2-in-1
- Base cover
- Battery
- Battery cable
- Keyboard
- Display assembly
- System board
- Speakers
- World-facing camera cable
- World-facing camera
- Display panel
- Front-facing camera
- Display hinges
- Display cable
- Display back-cover and antenna assembly
- Palm-rest assembly
- Troubleshooting
- Getting help and contacting Dell
Chromebook 3110 2-in-1 Service Manual
Installing the display hinges
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the display hinges and provides a visual representation of the installation procedure.
Steps
- Align the screw holes on the display hinges with the screw holes on the display back-cover.
- Replace the four screws (M2.0x3.0) and the six screws (M2.5x2.5) to secure the display hinges to the display back-cover.
- Rotate the display hinges close to an angle of 90 degrees.
- Gently push the G-sensor cable and wireless antennas into the right hinge cap.
- Gently push the display cable into the left hinge cap.
- Replace the hinge rubbers to secure the left and right hinge caps.
- Rotate the display hinges, and the hinge caps downwards away from the display cover.
NOTE:The display hinges should be at an angle of 0 degrees while the hinge caps should be at an angle of 90 degrees (or of the position of a closed laptop).NOTE:Ensure that the display hinges are rotated only to the unlock position, the hinge caps do not rotate until the display hinges are in the unlock position.
Next steps
- Install the display panel.
- Install the display assembly.
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\