Enabling and Disabling sFlow on an Interface
By default, sFlow is disabled on all interfaces.
This CLI is supported on physical ports and link aggregation group (LAG) ports.
To enable sFlow on a specific interface, use the following command.
Enable sFlow on an interface.
INTERFACE mode
[no] sflow ingress-enable
To disable sFlow on an interface, use the
no version of this command.
Enabling and Disabling sFlow for Egress Traffic
To enable sFlow on a specific interface for egress traffic, use the following command.
Enable sFlow on an interface.
INTERFACE mode
[no] sflow enable
To disable sFlow on an interface, use the
no version of this command.