Update replication and management endpoints in multiple VDCs
In an ECS geo-federated system, you can use the
Update All VDC Endpoints page to update replication and management endpoints in multiple VDCs.
Prerequisites
NOTEUpdate to endpoints on ECS requires assistance of ECS Professional Services to perform. Any change to endpoints without engaging ECS Remote Support could potentially lead to DU.
This operation requires the System Administrator role in ECS.
Update the VDC endpoints from the
Update All VDC Endpoints page after you have:
Separated the replication or management networks of a VDC in an existing ECS federation.
Changed the IP address of multiple nodes in a VDC.
If you attempt to update the VDC endpoints by editing the settings for an individual VDC from the
Edit Virtual Data Center <VDC name> page, you will lose connectivity between VDCs.
About this task
In an ECS geo-federated system with multiple VDCs, the IP addresses configured for ECS replication and management networks are used for connectivity of replication and management traffic between VDC endpoints. By default, all the ECS replication and management traffic is configured to run on the ECS public network, and by default the IP addresses of the public network that is configured for each node are used as the replication and management endpoints.
Optionally, you can separate the replication and management networks, and you must reconfigure the replication and management endpoints for a VDC.
Steps
In the ECS Portal, select
Manage > Virtual Data Center.
On the
Virtual Data Center Management page, click
Update All VDC Endpoints.
On the
Update All VDC Endpoints page, if the replication network was separated, or if the IP address for the node was changed, type the replication IP address of each node in the
Replication Endpoints field for the VDC. Type them as a comma-separated list.
On the
Update All VDC Endpoints page, if the management network was separated, or if the IP address for the node was changed, type the management IP address of each node in the
Management Endpoints field for the VDC. Type them as a comma-separated list.
Click
Update Endpoints.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\