Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC SmartFabric OS10 User Guide Release 10.5.1

PDF

Ethernet interfaces

Ethernet port interfaces are enabled by default. To disable an Ethernet interface, use the shutdown command. Use the show interface status command to view the status of the interfaces.

NOTE: Linux operation or commands such as shutdown or no-shutdown and ip-address that are run against the interface is not reflected in the CLI.

To reenable a disabled interface, use the no shutdown command.

  1. Configure an Ethernet port interface from Global CONFIGURATION mode. 
    interface ethernet node/slot/port[:subport]
  2. Disable and reenable the Ethernet port interface in INTERFACE mode. 
    shutdown
    no shutdown
Disable Ethernet port interface 
OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# shutdown
Enable Ethernet port interface 
OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# no shutdown

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\