Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC SmartFabric OS10 User Guide Release 10.5.1

PDF

deny ipv6

Configures a filter to drop all or specific packets from an IPv6 address.

Syntax
deny ipv6 [A::B | A::B/x | any | host ipv6–address] [A::B | A:B/x | any | host ipv6–address] [capture | count [byte] | dscp | fragment]
Parameters
  • A::B — (Optional) Enter the source IPv6 address from which the packet was sent and the destination address.
  • A::B/x — (Optional) Enter the source network mask in /prefix format (/x) and the destination mask.
  • any — (Optional) Set all routes which are subject to the filter:
    • capture — (Optional) Capture packets the filter processes.
    • count — (Optional) Count packets the filter processes.
    • byte — (Optional) Count bytes the filter processes.
    • dscp value — (Optional) Deny a packet based on the DSCP values, from 0 to 63.
    • fragment — (Optional) Use ACLs to control packet fragments.
  • host ipv6–address — (Optional) Enter the IPv6 address to use a host address only.
Default
Not configured
Command Mode
IPV6-ACL
Usage Information
OS10 cannot count both packets and bytes; when you use the count byte options, only bytes increment. The no version of this command removes the filter.
Example
OS10(config)# ipv6 access-list ipv6test
OS10(conf-ipv6-acl)# deny ipv6 any any capture session 1
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\