Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC SmartFabric OS10 User Guide Release 10.5.1

PDF

fspf hold-time

Configures the FSPF hold-time value for vfabric.

Syntax
fspf hold-time timeout-val
Parameters

timeout-val—Valid values are from 0 to 65535.

Defaults
0ms
Command Mode
VFABRIC CONFIGURATION
Usage Information
  • The configurations are supported only in multiswitch mode.
  • This command configures the hold-time between two consecutive route computations in milliseconds, for the entire vfabric. If the specified time is shorter, the routing update is faster. However, the processor consumption increases accordingly.
    NOTE: Configure the same hold timer value on all the switches for consistent route convergence, and to avoid intermittent traffic loop.
  • The no version of this command resets to the default value of 0ms.
Example 
OS10(conf-vfabric-<vfabric-id>)#fspf hold-time 5000
Supported Releases
10.5.1.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\