Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC SmartFabric OS10 User Guide Release 10.5.1

PDF

speed (Fibre Channel)

Configures the transmission speed of a Fibre Channel interface.

Syntax
speed {8 | 16 | 32 | auto}
Parameters
Set the speed of a Fibre Channel interface to:
  • 8 — 8GFC
  • 16 — 16GFC
  • 32 — 32GFC
  • auto — Set the port speed to the speed of the installed media.
Defaults
Auto
Command Mode
INTERFACE
Usage Information
  • To configure oversubscription for bursty storage traffic on a FC interface, use the speed command. Oversubscription allows a port to operate faster, but may result in traffic loss. QSFP28 breakout interfaces in 4x16GFC mode support 32GFC oversubscription.
  • The no version of this command resets the port speed to the default value auto.
Example 
OS10(conf-if-fc-1/1/2)# speed 16
Supported Releases
10.3.1E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\