Dell G7 7590 Service Manual

Procedure

NOTE Ensure that the touchpad is aligned with the guides available on the palm-rest assembly, and the gap on either sides of the touchpad is equal.

Slide and place the touchpad into the slot on the palm-rest assembly.
Align the screw holes on the touchpad bracket with the screw holes on the palm-rest assembly.
Replace the two screws (M2x3) that secure the touchpad bracket to the palm-rest assembly.
Replace the two screws (M1.6x2) that secure the touchpad to the palm-rest assembly.
Adhere the touchpad cable and slide the touchpad cable into the connector on the system board and close the latch to secure the cable.