iDRAC9 Version 5.00.00.00 Release Notes
Miscellaneous
- Configuring Power Factor Correction (PFC) for power supplies in all 15 th generation of PowerEdge systems is not supported.
- While BIOS is set to Boot mode, boot capture video file size is limited to 2 MB. During the video capture, if the size of video file exceeds the limit, then only partial operation is captured.
- CPLD update may fail if DUP method is used while power cap policy is enabled.
- Remote File Share (RFS) through HTTP is only supported without authentication.
- If part replacement is performed on systems with two PSUs while upgrade option is enabled, then the firmware update for both the PSUs are repeated once.
- IPMItool interface does not report noncommunicative PSU status for PowerEdge Rx4xx/Cx4xx servers.
- Arrow keys on virtual keyboard of the iDRAC Virtual Console with eHTML5 plug-in do not respond inside BIOS boot manager after the system reboots. Close and reopen the eHTML5 Virtual console session.
- If SOL session is active for a long duration or if the system is rebooted multiple times, the SOL session gets terminated automatically.
- For Dell online catalog update, downloads.dell.com only supports https protocol.
- If you install OMSA while iSM is already installed and connected, iSM may restart after the OMSA installation is complete.
- In SLES and RHEL, the native video players do not support the MPEG-1 video formats. To play the captured videos, install an MPEG decoder or a video player that supports this format.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\