Inspiron 13 7000 2-in-1 Service Manual

PDF

Procedure

  1. Slide the solid-state drive firmly into the slot on the system board at an angle and gently press the solid-state drive down until it snaps into position.
    • NOTE: Ensure that the solid-state drive is firmly seated.
  2. Press the other end of the solid-state drive and replace the screw that secures the solid-state drive to the palm-rest assembly.
    Image: Replacing solid-state drive
    1. screw
    2. solid-state drive
    3. solid-state drive slot
    4. system board
    5. palm-rest assembly

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\