- Notes, cautions, and warnings
- Notes, cautions, and warnings
- Working on your computer
- Disassembly and reassembly
- Recommended tools
- Screw List
- Major components of your system
- MicroSD card
- Base cover
- Battery
- Memory modules
- WLAN card
- Coin-cell battery
- DC-in port
- Solid-state drive
- Hard Drive
- Touchpad
- Speakers
- Fan
- Heat sink
- System board
- IO Board
- Power button
- Display assembly
- Display bezel
- Display panel
- Camera
- Display (eDP) cable
- Display back cover
- Palm-rest and keyboard assembly
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Enhanced Pre-Boot System Assessment (ePSA) diagnostics
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Updating the BIOS in Windows
- Updating the BIOS using the USB drive in Windows
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Latitude 3410 Service Manual
Installing the display bezel
About this task
Steps
Align the display bezel with the display assembly, and then gently snap the display bezel into place.
Next steps
- Replace the display assembly.
- Replace the battery.
- Replace the base cover.
- Replace the SD card.
- Follow the procedure in after working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\