- Notes, cautions, and warnings
- Notes, cautions, and warnings
- Working on your computer
- Disassembly and reassembly
- Recommended tools
- Screw List
- Major components of your system
- MicroSD card
- Base cover
- Battery
- Memory modules
- WLAN card
- Coin-cell battery
- DC-in port
- Solid-state drive
- Hard Drive
- Touchpad
- Speakers
- Fan
- Heat sink
- System board
- IO Board
- Power button
- Display assembly
- Display bezel
- Display panel
- Camera
- Display (eDP) cable
- Display back cover
- Palm-rest and keyboard assembly
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Enhanced Pre-Boot System Assessment (ePSA) diagnostics
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Updating the BIOS in Windows
- Updating the BIOS using the USB drive in Windows
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Latitude 3410 Service Manual
Removing the DC-in
Prerequisites
- Follow the procedure in Before working inside your computer.
- Remove the SD card.
- Remove the base cover.
- Disconnect the battery cable.
About this task
The figure indicates the location of the DC-in and provides a visual representation of the removal procedure.
Steps
- Locate the DC-in port on your computer, remove the three (M2.5x5) screws from the hinge covering it.
- Lift the hinge and fold it away from the chassis.
- Disconnect the DC-in cable from the computer and remove the single (M2x3) screw.
- Remove the DC-in port from the computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\