Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Latitude 3410 Service Manual

PDF

Installing the Power Button

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The figure indicates the location of the power button and provides a visual representation of the installation procedure.

IO board install

Steps

  1. Place the Power Button module onto the mounting points on the palmrest.
  2. Place the shield on top of the power button module and install the two (M2x2) screws to secure the shield onto the power button.
  3. Connect the cable connector to the daughterboard module.

Next steps

  1. Install the Solid state drive.
  2. Install the IO board.
  3. Install the battery.
  4. Install the base cover.
  5. Install the SD Card.
  6. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\