Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC SmartFabric OS10 User Guide Release 10.5.1

PDF

ipv6 route bfd

Enables or disables BFD on IPv6 static routes.

Syntax
ipv6 route [vrf vrf-name] bfd [interval millisec min_rx min_rx multiplier role {active | passive}]
Parameters
  • vrf vrf-name — Enter the keyword VRF and then the name of the VRF to configure static route in that VRF.
  • interval milliseconds — Enter the time interval for sending control packets to BFD peers, from 50 to 1000.
  • min_rx milliseconds — Enter the maximum waiting time for receiving control packets from BFD peers, from 50 to 1000. Dell EMC recommends using more than 100 milliseconds.
  • multiplier number — Enter the maximum number of consecutive packets that must not be received from a BFD peer before the session state changes to Down, from 3 to 50.
  • role {active | passive} — Enter active if the router initiates BFD sessions. Both BFD peers can be active simultaneously. Enter passive if the router does not initiate BFD sessions, and only responds to a request from an active BFD to initialize a session.
Default

The time interval for sending control packets to BFD peers is 200 milliseconds.

The maximum waiting time for receiving control packets from BFD peers is 200 milliseconds.

The number of consecutive packets that must be received from a BFD peer is 3.

The BFD role is active.

Command Mode
CONFIG
Usage Information
  • Use this command to enable or disable BFD for all the configured IPv6 static routes for the specified VRF. If you do not specify a VRF name, the command is applicable for the default VRF.

The no version of this command disables BFD on an IPv6 static route.

Example 
OS10(config)# ipv6 route bfd interval 250 min_rx 250 multiplier 4 role active
Supported releases
10.4.2E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\