- Notes, cautions, and warnings
- Working on your computer
- Chassis
- Field service information
- Screw size list
- Recommended tools
- Critical callouts
- Working on your computer
- Disassembly and reassembly
- Side Cover
- Front Bezel
- Front panel door
- Installing front panel door
- Storage device
- Optical drive
- M.2 PCIe SSD
- SD card
- Memory modules
- Expansion card
- Power supply unit
- Intrusion switch
- Power switch
- Speaker
- Coin-cell battery
- Heat sink assembly
- Processor
- System fan
- VGA Daughterboard
- System board
- Technology and components
- System setup
- Troubleshooting
- Getting help
Dell OptiPlex 5055 Ryzen APU Tower Owner's Manual
Enabling data wipe option in BIOS
After replacing the system board and successfully setting the service tag, the system will reboot. If the technician enters the BIOS at this point, the Data Wipe option will not be available. To re-enable Data Wipe, simply power down the system, then power it back up (cold boot). The Data Wipe option is now available.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\