- Notes, cautions, and warnings
- Views of OptiPlex Tower 7010
- Set up your computer
- Specifications of OptiPlex Tower 7010
- Working inside your computer
- Removing and installing side cover
- Removing and installing coin-cell battery
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- BIOS Setup
- Troubleshooting
- Getting help and contacting Dell
OptiPlex Tower 7010 Owner's Manual
Installing the speaker
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the speaker and provides a visual representation of the installation procedure.
Steps
- Press the tab on the speaker and slide the speaker into the slot on the chassis until it snaps into place.
- Press down on the speaker to secure the speaker with the tab on the chassis.
- Route the speaker cable through the routing guide on the chassis.
- Connect the speaker cable to the connector on the system board.
Next steps
- Install the side cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\