Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

OptiPlex Tower 7010 Owner's Manual

Screw list

NOTE:When removing screws from a component, it is recommended to note the screw type, and the quantity of screws, and then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is restored when the component is replaced.
NOTE:Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when replacing a component.
NOTE:Screw color may vary with the configuration ordered.
Table 1. Screw listThe following table provides the different screws that are used in your OptiPlex Tower 7010.
Component Screw type Quantity Screw image

Left-Side cover

Captive screw

2

Captive screw

M.2 2230/2280 Solid-state drive

M2x3.5

1

M3x3.5

2.5-inch Hard-disk drive

M3x3.5

4

M3x3.5

3.5-inch Hard-disk drive

6-32

4

6-32

WLAN card

M2x3.5

1

M3x3.5

Power-supply unit

#6-32

3

#6.32x5.4

125 W heat-sink assembly

Captive screw

4

Captive screw

Processor fan (for 125 W heat-sink assembly

Captive screw

4

Captive screw

VR heat sink

Captive screw

2

Captive screw

Serial/VGA module

4-40x6.5

2 4-40x6.5

DisplayPort/HDMI module

M3x3

2 Image: M2x3 screw

System board

#6-32

6-32

6-32

2

1

8

#6-32

M2x4

#6.32x5.4


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\