- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw List
- Major components of your system
- Side cover
- Front bezel
- Hard-drive assembly
- Removing the primary 2.5-inch hard-drive assembly
- Removing the secondary 2.5-inch hard-disk drive assembly
- Removing the 2.5-inch hard-disk drive bracket
- Installing the 2.5-inch hard-disk drive bracket
- Installing the secondary 2.5-inch hard-disk drive assembly
- Installing the primary 2.5-inch hard-drive assembly
- 3.5 in. hard-drive assembly
- Solid-state drive
- Memory module
- Processor fan and heat-sink assembly
- Processor
- Graphics card
- Graphical processing unit
- Coin-cell battery
- WLAN card
- Slim optical-drive
- Slim optical-drive bracket
- Chassis fan
- Voltage regulator heat sink
- Speaker
- Power button
- Power-supply unit
- Intrusion switch
- Optional I/O modules (Type C/ HDMI/VGA/DP/Serial)
- System board
- Software
- System setup
- Troubleshooting
- Getting help and contacting Dell
OptiPlex 7090 Tower Service Manual
Removing the powered GPU
Prerequisites
- Follow the procedure in before working inside your computer.
- Remove the side cover.
About this task
The following images indicate the location of the powered graphical processing unit and provide a visual representation of the removal procedure.
Steps
- Disconnect the two power cables from the connectors on the powered GPU through the cable holder.
- Unroute the power cable from the retention tab on the cable holder.
- Press the securing clips on both side of the power-cable holder and slide the powered GPU cable holder out of the computer.
- Lift the pull tab to open the PCIe door.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\