- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw List
- Major components of your system
- Side cover
- Front bezel
- Hard-drive assembly
- Removing the primary 2.5-inch hard-drive assembly
- Removing the secondary 2.5-inch hard-disk drive assembly
- Removing the 2.5-inch hard-disk drive bracket
- Installing the 2.5-inch hard-disk drive bracket
- Installing the secondary 2.5-inch hard-disk drive assembly
- Installing the primary 2.5-inch hard-drive assembly
- 3.5 in. hard-drive assembly
- Solid-state drive
- Memory module
- Processor fan and heat-sink assembly
- Processor
- Graphics card
- Graphical processing unit
- Coin-cell battery
- WLAN card
- Slim optical-drive
- Slim optical-drive bracket
- Chassis fan
- Voltage regulator heat sink
- Speaker
- Power button
- Power-supply unit
- Intrusion switch
- Optional I/O modules (Type C/ HDMI/VGA/DP/Serial)
- System board
- Software
- System setup
- Troubleshooting
- Getting help and contacting Dell
OptiPlex 7090 Tower Service Manual
Installing the WLAN card
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the wireless card and provides a visual representation of the installation procedure.
Steps
- Connect the antenna cables to the WLAN card.
The following table provides the antenna-cable color scheme for the WLAN card of your computer.
Table 1. Antenna-cable color schemeThe table provides the antenna-cable color scheme for the WLAN card: Connectors on the wireless card Antenna-cable color Main (white triangle) White Auxiliary (black triangle) Black - Place the WLAN card bracket to secure the WLAN antenna cables.
- Insert the WLAN card into the connector on the system board.
- Replace the (M2x3.5) screw to secure the plastic tab to the WLAN card.
Next steps
- Install the
powered GPU.
NOTE This step is required only if the system is configured with powered GPU.
- Install the side cover.
- Follow the procedure in after working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\