Dell OptiPlex 7770 All-in-One Service Manual

Removing the pop-up camera

1. Follow the procedure in Before working inside your computer.
2. Remove the following components:
   1. Stand
   2. Back cover
   3. System board shield
3. To remove the camera assembly:
   1. Remove the two screws (M3x5) that secure the camera assembly cover to the middle frame [1].
   2. Lift the camera assembly cover away from the middle frame [2].
   3. Disconnect the camera cable from the system board and unroute the camera cable from the routing channel [3].
   4. Remove the two screws (M3x5) that secure the pop-up camera assembly to the middle frame [4].
   5. Slide and lift the pop-up camera assembly off the middle frame [5].
      
4. To remove the camera bezel:
   1. Press the top of the pop-up camera assembly to extend the pop-up camera [1].
   2. Remove the three screws (M3x5) that secure the bezel to the pop-up camera assembly [2].
      
5. To remove the pop-up camera module:
   1. Lift the pop-up camera bezel off the pop-up camera assembly [1].
   2. Remove the camera module along with the camera cable off the pop-up camera assembly [2]