If Lifecycle
Controller causes the system to restart twice, cancel the Lifecycle
Controller actions. However, if Lifecycle Controller causes the system
to restart the third time, the message Lifecycle Controller
update required is displayed, you must enable Lifecycle Controller.
For more information on enabling Lifecycle Controller, see Enabling Lifecycle
Controller.
CAUTION: This action cancels all tasks that are being performed
by Lifecycle Controller. It is recommended that you cancel the Lifecycle
Controller actions only when absolutely necessary.
Press <F2> during POST.
The System Setup Main Menu page
is displayed.
In the System Setup Main Menu page,
select iDRAC Settings.
The iDRAC Settings page is displayed.
Select Lifecycle Controller.
Under Cancel Lifecycle Controller Actions, select Yes.
On the System Setup Main Menu page,
select Finish to save the settings.
Select Yes to restart the system.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\